![]() When power is more important than economy, the ratio of the CVT can be changed to allow the engine to turn at the RPM at which it produces the greatest power. As the contact area is proportional to the number of elements, chain belts require many very small elements.Ī belt-driven design offers approximately 88% efficiency, which, while lower than that of a manual transmission, can be offset by enabling the engine to run at its most efficient RPM regardless of the vehicle's speed. As the chain moves into the pulleys the contact area gets smaller. Each element of the chain must have conical sides that fit the pulley when the belt is running on the outermost radius. Steel-reinforced V-belts are sufficient for low-mass, low-torque applications like utility vehicles and snowmobiles, but higher-mass and -torque applications such as automobiles require a chain. The radial thickness of the belt is a compromise between the maximum gear ratio and torque. ![]() The V-belt needs to be very stiff in the pulley's axial direction to make only short radial movements while sliding in and out of the pulleys. ![]() Simple CVTs combining a centrifugal drive pulley with a spring-loaded driven pulley often use belt tension to affect the conforming adjustments in the driven pulley. Īs the distance between the pulleys and the length of the belt does not change, both pulleys must be adjusted (one bigger, the other smaller) simultaneously to maintain the proper amount of tension on the belt. The V-shaped cross-section of the belt causes it to ride higher on one pulley and lower on the other therefore, the gear ratio is adjusted by moving the two sheaves of one pulley closer together and the two sheaves of the other pulley farther apart. The V-belt runs between these two halves, so the effective diameter of the pulley is dependent on the distance between the two halves of the pulley. The pulleys consist of two cone-shaped halves that move together and apart. The most common type of CVT uses a V-belt which runs between two variable-diameter pulleys. The pulley's effective diameter is changed by pushing the two conical discs either towards or away from each other.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |